Dart3D Wall Mount Guide Tool - Guide

The Wall Mount Guide Tool has been designed to help make installation easier

Please see the video below for a quick overview of how this tool should work.

NOTE: the holes in the tool are the correct distance for Dart3D arms. If you are using a different design, please check the holes line up before drilling into the wall.

1. Assemble the tool by pushing the three diamonds through the holes - this should be quite tough to do as it needs to be tight to ensure a straight line.
2. Remove your board and make a center point mark in the mounting clip where the screw of the dartboard sits (bullseye)
3. Remove the mounting clip from the wall
4. With the centre mark visible in the centre hole, use a spirit level to make sure the tool is level.
5. It is best to hold the tool in the middle where the join is, to avoid it moving whilst in place.
6. Run a pencil or pen through the slits, and mark out the screw holes.
7. Turn the tool 120° and make sure the centre point and three lines are visible through the slits. Make marks in the screw holes.
8. Turn 120° once more and make the final screw marks.
9. Your wall should now be fully marked ready for drilling! Please double check all measurements again before drilling!