Target Mount - Autodarts Setup Guide

Thank you for purchasing your Autodarts Mounts from my store—I really appreciate it!

This guide is for the original Target Mounts.

I hope you’re happy with your camera mounts. If you have any questions or issues, please get in touch and I’ll do my best to help. My aim is to get you up and running with Autodarts as smoothly as possible.

We also sell on eBay as Hippo3dPrints.

A few important notes:

  • All of the screws you need are included, I have pre screwed them in place to keep them safe. You will need to unscrew the lid to remove them.
  • These mounts are designed for OV9732 cameras.
  • When your cameras arrive, you may need to break off the outer edge of the board for them to fit—this is standard practice for these models. Let me know if you need more help with this.
  • The mounts clip onto three of the four Target Corona Vision legs and can be stabilized using the included clips.
  • These prints are PLA and not plastic, please take care putting them on and taking them off as they can snap with too much force.
  • Please do not use any powertools or drills with 3d prints!
  • You can also find many helpful people in the Autodarts Discord

If you bought mounts with cameras, skip to the Installation step

Camera set up

Unscrew the lids, there are 2 small screws at the bottom of the lid that will allow you to remove it from the front of the mount.

You will find 4 screws underneath the lid, this is where the camera will be held in place.

If your cameras have arrived with an outer border like below, you will need to remove them in order for them to fit in the mount

ov9732 cameras for Autodarts

I usually remove them by clipping the corners with wire cutters and then gently pulling at the border with up and down motions:


Once the cameras are the right size, they can be screwed into the mount, using 4 screws. The cable port should be at the top of the mount:


When the camera is screwed in place, you can connect the cable (ensure the clip is the right way) and screw the lid back on. The cable should go through the hole at the bottom center of the lid. You will need to hold the lid shut firmly whilst using two screws to secure the lid to the mount:


Installation 

Once your mounts are ready to be connected to the light ring, they can be gently connected to the light ring legs. Use both hands to slide the mount into position. To remove, use both thumbs to push the mount off the light ring.

The clips can be used to minimize shaking of the light ring.



Plug all three USB cables into USB 2.0 ports on your device and load up the Autodarts software.

If you have any further questions you can contact me via the chat function. And if you like this product, please leave a review (on eBay or this website, or both if you're feeling generous!)

Thank you! See you in a tournament! Jack 🎯